This is a NEW very heavy duty, complete head mounting and leveling fixture for surfacing heads on a cylinder head resurfacing machine that uses t-slot parallel risers. The parallel risers are not included. It is perfect for surfacing with a CBN cutter insert.
It fits Sunnen, Kwik Way, DCM, RMC, Storm Vulcan, Winona and other resurfacing machines.
There is an eccentric cam on the head plate to adjust the X axis and an adjustable work support stand to adjust the Y axis.
You can install and level a cylinder head in five minutes.
This is a very heavy duty holding fixture. A ridged fixture is very important in achieving the desired surface finish.
The precision ground V-blocks are 6″ X 2.5″ and the hold down bar is 1″ x 2″ x 7.5″.
The v-blocks rest directly on the parallels with a locator in the bottom to keep them centered. They are free floating so they re-center every time you tighten the clamp bar.
The bar is made from high carbon steel that has been turned ground and polished. It is a precision 2″ diameter bar. It is 40″ long.
The roll over bar can be used to resurface engine blocks. It is a precision 2" bar. It has a flat side machined on it so it can be used with or without BHJ rings.
A block holding tooling kit and an additional short work support stand is available for $475.00. It is not included in the $1200.00 head fixture assembly.
The head mounting plate is made from very high quality aluminum and it was machined on a HAAS CNC machining center right here in the United States of America.
The head plate dimensions are 26″ X 6″ X .750″.
All the studs, flange nuts and t-slot nuts are included.
The price is $1200.00
I will refund the purchase price and pay for all the shipping if the buyer is not satisfied.
Crating and shipping cost a flat $95.00 anywhere in the lower 48 States.
Call me at 828-208-6000 if you have any questions.